LAZER tattoo removal machine Repair IPL Hair removal

#LASER #Tattoo Removal hair removal repairs for your machines.

If you have purchased a new ipl or tattoo removal lazer device from China you may have noticed that the power has not been delivered as it should be; when it was shipped as new machine.

Has the spot size of your lazer got smaller and weaker?

Your tattoo removal lazer machine does not work like it did when it was new?

Has your ipl hair removal machine lost power and does not work properly?

I can help you.

I can provide assistance.

PLEASE note. You should replace the coolant every 10 to 14 days. As the deionized water will fail.

Secondly the consumable parts of the machine will be nearing the expiry date. Usually the lamp which powers the laser.

PLEASE SEE the sizes of the lamp you require.

See below before ordering your spare laser lamp.

All machines use different size lamps so here are some popular sizes that I can supply you today.

200mm length by 7mm thickness.

140mm length by 6mm thickness.

140mm length by 7mm thickness.

130mm length by 7mm thickness.

115mm length by 7mm thickness.

I can provide you with all sizes on the market but one will not fit all of the other machines.

Usually a tattoo removal laser will be 140mm. Length.

IPL HAIR REMOVAL machine are 130mm length.

PLEASE ask the supplier you purchased the machine from; what size lamp is in the machine?

Or dare to open the handpiece and measure end to end of the lamp.

No need to drain the water at this point in time. Just make sure that you have unplugged the machine from the mains power supply.

send me a pic of the lamp with the tape measure next to the lamp. Then we can go forward.

I will be very happy to help you identify the best possible solution if you can not get help from the supplier.

all I need to see is the photo of the handpiece opened. With a ruler next to the lamp. Then screw the handle back together.

My guess is the tattoo removal lazer lamp is 140mm length.

As this is the most likely one you will have for the tattoo removal lazer. 6mm or 7mm thickness.

I can usually tell be seeing the machine and lamp pictures.

PLEASE SEE my solution for your convenience.

When you receive your new lazer or ipl lamp; All you need to do is ;

1) open the handpiece when you drain the water off. Unplugged from the mains of course.

2) pull out the old lamp. This may be soldered in.

3) push in the new lamp that I have supplied you with.

4) tighten the supplied clamps at either end of the lamp with the wires inside the clamps. Alternatively you can solder the lamp in.

Job done. Your Happy. A 5 minute job well done.

It is always best to watch a video on YouTube how to fit a replacement laser lamp.

And I would suggest using heat shrink tubing or some other materials that are non conducting to ensure that the electrical power does not short to any other parts inside the handpiece.